Try this

Mminfo -X -q "savetime>Fullbackupstarttime,savetime<Fullbackupendtime"

Regards

Andrew McGeorge
Senior Systems Specialist
Group Technology Operations


-----Original Message-----
From: Ciolek, Ken [mailto:Ken.Ciolek AT AIG DOT COM]
Sent: 17 December 2003 2:57AM
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] mminfo question


Using Mminfo how can I gather the amount of data that was backed up in the
last FULL backup

Ken Ciolek
SAN Storage Administrator
Open Systems Support - Storage
AIG Technologies
(973)533-2094
(973)277-1148 (Cell)
(888)463-9721 (Pager)
Ken.Ciolek AT aig DOT com


--
Note: To sign off this list, send a "signoff networker" command via email to
listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can also view
and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

========================================================================================
This email message and attachments are confidential to our organisation and 
subject to legal privilege.  If you have received this email in error, please 
advise the sender immediately and destroy the message and any attachments. If 
you are not the intended recipient you are notified that any use, distribution, 
amendment, copying or any action taken or omitted to be taken in reliance of 
this message or attachments is prohibited.  You can read our Privacy Policy 
here: <http://www.asbbank.co.nz/privacystatement.stm>
=========================================================================================

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=