Dear Networkers,
I have trouble configuring a Quantum dx30 (posing as an ATL P1000 with 6
DLT 7000) on a SunFire 280 running Solaris 8 and Networker 7.0.
Probe-scsi-all sees the library and the tapes and a boot -r resultedin
the correct links under /dev/rmt. Unfortunately neither inquire nor
jbconfig with or without the -l switch see the robotic or the tape
drives.
The dx30 is attached to a Qlc 2342 fibre channel controller.
Thanks for any insight you can offer on this.

Regards

~christian

--
Christian Drexler               mail: cdrexler AT tee.toshiba DOT de
Systems Administrator           phone: +49 211 5296 322
Toshiba Electronics Europe      fax: +49 211 5296 9322
Duesseldorf, Germany            http://www.toshiba-europe.com


**********************************************************************
CONFIDENTIALITY DISCLAIMER

The information in this email and in any attachments is confidential and may be
privileged.  If you are not the intended recipient, please destroy this message,
 delete any copies held on your systems and notify the sender immediately.

You should not retain, copy or use this email for any purpose outside of any NDA
currently existing between Toshiba Electronics Europe GmbH and yourselves.
**********************************************************************

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=