Re: [Networker] St.conf setting for LTO2 drives
2003-10-20 11:44:02
Recently I had similar problems, Dawina reminden me to have all recent patches
on solaris 9 (I use Sol 8) and that LTO2 is not officially supported. There
is no media type LTO2 in 6.1.2 it is there as of 6.1.3. We upgraded to 7.0.
The st.conf is not realy needed in my case as the IBM LTO-2 tapes are nativly
suported in the /kernel/drv/st binary
in my case I could check that with:
strings /kernel/drv/st | grep -i IBM
thet should give the same hardware string as comes from the inquire command in
/etc/LGTO. ( by the way it is in /usr/sbin on networker 7 )
in my case strings /kernel/drv/st | grep -i HP ,gives me
HP Ultrium LTO 2
HP Ultrium LTO
Hope it helps,
Maarten
On Monday 20 October 2003 17:22, you wrote:
> I just got two Sun L25 jukeboxes with HP LTO2 drives. Backups seem to work
> fine but the old problem with tape positioning for restores is cropping up.
> Cloning is also extremely slow on multiplexed backup sets. Both of these
> problems are, I believe, because I need the st.conf settings for the LTO2
> drives.
>
> I'm running Solaris 9 and Networker 6.1.2.
>
> I found a few things on the Legato site but it always pays to ask the group
> as well. Does anyone have the answer.
>
> Thanks.
>
> Jim Edwards
> Systems Manager
> Texas Secretary of State
>
> --
> Note: To sign off this list, send a "signoff networker" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|