[Networker] AW: [Networker] One system write to two drives @ once?

It's possible, shure. Decrease "target sessions" in your device resources.
If both drives have access to all pools, the save should use them all. The
value in "target sessions" is not a limit, it is used as load balancing

regards

Klaus 



mailto:klaus.grohal AT siemens DOT com


-----Ursprüngliche Nachricht-----
Von: Tammy George [mailto:tammy.george AT ACADIAU DOT CA] 
Gesendet: Mittwoch, 10. September 2003 14:07
An: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Betreff: [Networker] One system write to two drives @ once?


Hello.

We are evaluating our present backup configuration and the bosses have
asked me if it is possible for one server to write to two tapes at once.
I'm
thinking we can't but have no evidence to back this up so I'm hoping someone
here can validate or deny my suspicions.

We have two DLT7000 drives.  Networker runs on a Unix box & we backup unix
systems, novell servers & NT systems.  When backups run, it appears that
each
server is only capable of writing to one tape at a time - many systems run
at
once & we have 4 or 5 systems writing to each tape at a time.

For example, one of our servers is ACE - Novell server.  It's over 200 gig
in
size & presently takes around 10 hours to backup (while other systems are
running at the same time).  And it writes to only one tape at a time.  Would
it be
possible to configure it to write to two tapes at once?

Hope I didn't confuse the issue too much.

Thanks in advance for any information.

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=