Hello Folks,

I have a Networker 6.1.1 Build 238 running on a Solaris 6 System with
DLT7000 Tape Drives.

Yesterday , i received two Tapes from a remote site and i was
sucessfully able to scan the media and the client indexes of the
client i wanted to restore.

However everytime i start the recovery, the system will start to Load
the required tape -->Verifies the label --> Moves Backward 2 Files -->
Waits for a few sceonds --> Again starts to verify the Tape Label

This loop of verify tape label goes on indefinetly , until i cancel the
recover.

Other Tapes for regular backups work fine.

I have also tried to disable "Match Barcode Label with volume" with no
benefit.

Any clues how to correct this, or any mechanism to restore files without
having the system to verify labels ?

Rgds,

Monit

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=