If I understand your question correctly, I think the problem lies more in
the fact that client initiated saves are classified as manual as far as
level, so perhaps a solution for you is to make sure whatever pool you wish
it to go to has manual as an option, then make sure you use the -b pool
option to direct it where you want.

pt

On Wed, 16 Apr 2003 19:29:48 -0400, Yura Pismerov <ypismerov AT TUCOWS DOT COM>
wrote:

>          When I run "save" command on a client it starts backing up to
>Default group.
>Why don't it use whatever group the client is set up for in the NSR
>Client settings ?
>If this is a "feature", then how can I setup different default group for
>the client that will be used by either "save" or nwbackup ? Other than
>that nwbackup does not even give me a choice of the groups/pools...
>
>         TIA.
>
>--
>Note: To sign off this list, send a "signoff networker" command via email
>to listserv AT listmail.temple DOT edu or visit the list's Web site at
>http://listmail.temple.edu/archives/networker.html where you can
>also view and post messages to the list.
>=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=