Try running recover from the command line on the system you are recovering
to. This might make the problem more obvious.

Andrew

-----Original Message-----
From: disno [mailto:disno AT MANDAWANI DOT COM]
Sent: 12 March 2003 7:56:PM
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] Directed Recover


Hi, all

we want to directed recover from W2k client to W2k client form networker
server, but we get error messages
"unknown error 1326 (0x52e)
Any suggestions greatly appreciated

thank's
Best Regards,

 D I S N O



--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

========================================================================================
This email message and attachments are confidential to our organisation and 
subject to legal privilege.  If you have received this email in error, please 
advise the sender immediately and destroy the message and any attachments. If 
you are not the intended recipient you are notified that any use, distribution, 
amendment, copying or any action taken or omitted to be taken in reliance of 
this message or attachments is prohibited.  You can read our Privacy Policy 
here: <http://www.asbbank.co.nz/privacystatement.stm>
=========================================================================================

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=