Re: [Networker] How to order tapes

Hi again,

Thanks for your answers, now I'll label the tapes in order.

A had some problems, right after installation, when the NetWorker marked
tapes as full after writing just few GB(on DLT IV tapes). I don't know the
reason, but I think the temperature in the DLT loader room was to high.
After a while, I've modified the tapes from full to appendable, and
Networker start to use them again. But in our backup policy, the full
tapes from quarter start are moved offsite, and never reused, so on more
tapes, I had a lot of old data, but also a needed saveset, and I can't
reuse the tape.

So, in fact, I was looking for a way to group a full backup (not any) to a
group of tapes.

thanks again

 --
______V______   Ciprian Badescu
A L C A T E L   Mobile Networks Division R&D Center
Email: Ciprian.Badescu AT alcatel DOT ro

On Tue, 4 Feb 2003, Stan Horwitz wrote:

> Date: Tue, 4 Feb 2003 13:01:48 -0500
> From: Stan Horwitz <stan AT TEMPLE DOT EDU>
> Reply-To: Legato NetWorker discussion <NETWORKER AT listmail.temple DOT edu>,
>      Stan Horwitz <stan AT TEMPLE DOT EDU>
> To: NETWORKER AT listmail.temple DOT edu
> Subject: Re: [Networker] How to order tapes
>
> On Mon, 3 Feb 2003, Ciprian Badescu wrote:
> >
> > I don't know in which order The NetWorker server is loading the tapes. Any
> > help ?
>
> I am curious, why does it matter which order your tapes are used?
> NetWorker is pretty good at deciding for itself which tapes to use.
>
> --
> Note: To sign off this list, send a "signoff networker" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=