[Networker] cloning savesets resulted in partial clone
2003-02-04 17:51:29
Networkers,
I just ran into a serious problem when cloning savesets:
I have 2 tape drives. client parallellism=4, server parallellism=8. I ran
a full backup of 2 clients and data was streaming to both drives. As tapes
would fill, some savesets were continued on 2nd tape. The 2 clients had
savesets written on a total of 3 tapes. No problem.
When I used the gui to clone the savesets (selecting saveset clone not
volume clone) I was presented with the list of savesets. I cloned them,
however, only 2 source tapes were used and it all wrote to 1 tape. (H/W
compression is on both drives.) It appears that savesets that spanned
volumes did not have the data from the spanned volume cloned. The clone,
which filled 2+ tapes, fit on less than 1 tape. When I look at the volumes
(using gui) all 3 volumes list the savesets as cloned. However I KNOW that
the 3rd tape was never loaded. The "completed" clone tape is 95GB. Tapes
1 and 2 together are 188GB (tape 3 is another 30GB).
Is there an explaination for this networker behaviour?
Thanks
Chuck Davis
Walter Reed Army Medical Center
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] cloning savesets resulted in partial clone,
Chuck Davis <=
|
|
|