Re: [Networker] Block Size Questions
2003-01-28 10:54:56
Check your st.conf file, it most likly has no config for the 9840 drives.
You shoudl be able to get htis from the STK web site. Also I think that the
STK NT driver should run at 256K. Label a tape on Unix, write some data,
then mount it with NT machine and scan the tape, if you get no errors you
are good to go.
Original Message:
-----------------
From: Joel Fisher jfisher AT WFUBMC DOT EDU
Date: Tue, 28 Jan 2003 10:49:07 -0500
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: [Networker] Block Size Questions
Hey All,
Sun E450
Solaris 2.6
Solstice Backup 6.1.2
StorageTek 9310 Silo with 9940B drives
We just purchased a STK Silo with 9940B drives, and when I label a tape
I get the below messages.
01/28/03 09:34:23 nsrd: media notice: Volume "" on device
"/dev/rmt/18cbn": Block size is 80 bytes not 262144 bytes. Verify the
device configuration. Tape positioning by record is disabled.
01/28/03 09:34:23 nsrd: media warning: /dev/rmt/18cbn reading: Tape
label read: I/O error
01/28/03 09:34:25 nsrd: /dev/rmt/18cbn Label without mount operation in
progress
01/28/03 09:34:41 nsrd: media notice: Volume "Unknown" on device
"/dev/rmt/18cbn": Block size is 80 bytes not 262144 bytes. Verify the
device configuration. Tape positioning by record is disabled.
01/28/03 09:35:09 nsrd: /dev/rmt/18cbn Eject operation in progress
This was a brand new tape. Is the block size after labeling now 256K or
80bytes? Since it's been labeled will positioning by record be enabled?
When I relabel the tape I don't get the block size message, but I'm not
sure what size blocks the tape is currently using.
These drives will be used for DDS with a WIN2K system so I need to set a
block size. Any suggestion for the best block size for compatibility
and performance? I haven't been able to find much info on WIN2K max
block size, so if anyone knows where I can find that type of data I
would appreciate it.
I see similar questions answered in the archives, but I was wondering if
anyone had any more detail.
TIA,
Joel
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|