In regard to: [Networker] how to avoid tape dismount/re-mount cycle., Jim...:
>Hi, All
>
>when I use "nsrjb -L" to label a tape and assign it to a pool,
>Networker dismounts the tape immediately after it's finished. if I want
>to use that tape right away it has to be re-mounted. given that each
>mount and dismount cycle seems to take about 5 minutes this is a bit of
>a pain. I can't see anything about this in the nsrjb manpage but I'm
>wondering if there's some way to label a tape and specify that it should
>remain mounted afterwards? I'm using Networker 6.0 with an STK 9710
>library.
Jim-
Read the section on `-L' again, especially the last paragraph (about
the -m option).
This is documented in the 6.1.3 version of NetWorker, and I seem to
recall reading about this a long time back, so I think it's been around
for a while (and should therefore be present in 6.0).
Tim
--
Tim Mooney mooney AT dogbert.cc.ndsu.NoDak DOT edu
Information Technology Services (701) 231-1076 (Voice)
Room 242-J6, IACC Building (701) 231-8541 (Fax)
North Dakota State University, Fargo, ND 58105-5164
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|