Re: [Networker] FW: [Networker] Pull by Pool doesn't work for 6.1.2
2002-12-03 08:32:56
You could make a group that holds all clients, assign it's own pool, label
volumes for that pool on a filesystemdevice and then
run the group from cron with:
savegrp -O groupname
This will only backup the indexes and the bootstrap information.
Regards,
Dirk Verhoeff
---------------------------------------------------------------------------
This message (including any attachments) is confidential and may be
privileged. If you have received it by mistake please notify the sender by
return e-mail and delete this message from your system. Any unauthorised
use or dissemination of this message in whole or in part is strictly
prohibited. Please note that e-mails are susceptible to change.
ABN AMRO Bank N.V. (including its group companies) shall not be liable for
the improper or incomplete transmission of the information contained in
this communication nor for any delay in its receipt or damage to your
system. ABN AMRO Bank N.V. (or its group companies) does not guarantee that
the integrity of this communication has been maintained nor that this
communication is free of viruses, interceptions or interference.
---------------------------------------------------------------------------
--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
|
|