Hi Chris.  I hope this info helps.  I just completed an install of 6.1.2 on
Solaris (8) and a 2 drive STK L40 (DLT 7000).  Fresh install and absolutely
no issues.

-Tom




-----Original Message-----
From: Chris Adkisson [mailto:cadkisson AT BBANDT DOT COM]
Sent: Friday, November 22, 2002 9:03 AM
To: NETWORKER AT LISTMAIL.TEMPLE DOT EDU
Subject: Re: [Networker] networker 6.1.1 and L700 problem


Just wanted to see if anyone else has seen this or found a fix for it.  I
upgraded to 6.1.2 last weekend and have gotten the same error with nsrjb -
HEv, nsrjb -IEv, and nsrjb -u.  This is on E4500, running Solaris 7, with
an attached STK L700 with 20 Quantum DLT7000's.

I loaded 6.1.2 in my lab (install, not upgrade) on a E220R with a STK L20
and 2 Quantum DLT7000's, and I get the same exact error.

I opened a case with Legato yesterday and they told me that I upgraded my
E4500 incorrectly.  I was at 5.5.5 and went straight to 6.1.2.  They claim
that my problem is because I didn't go to 6.0 first, before upgrading to
6.1.2.  Then I told them about my lab setup so the call is still open today.

Any thoughts?

--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=

--
Note: To sign off this list, send a "signoff" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=