Re: [ADSM-L] Tivoli Server Specs
2012-05-02 13:52:55
Thanks Andy! This helps.
Craig
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT vm.marist DOT edu] On Behalf Of
Huebner,Andy,FORT WORTH,IT
Sent: Wednesday, May 02, 2012 12:34 PM
To: ADSM-L AT vm.marist DOT edu
Subject: Re: [ADSM-L] Tivoli Server Specs
I have about 500 nodes on my p5's running 5.4 and they are on the edge.
The P7's running 6.2 have less than 250 nodes and are overpowered.
Testing indicates that the upgrade of the p5's to p6's and 6.2 will leave room
to grow.
All 6.2 servers are 32GB. The p7's are 2 CPU and the p6's are 4 CPU. All are
allowed to steal CPU (LPARs are great). The disks are SAN attached, I am using
real and imagined tape and disk pools.
I do not dedup with TSM.
Things to consider:
1. if you can complete your backups in the window you have enough network
bandwidth 2. if you can complete expiration in a reasonable time you have
enough CPU 3. if you can complete reclamation in a reasonable time you have
enough storage bandwidth
The hard part is all three can be affected by slow disk, not enough RAM and a
busy CPU.
Profile the current server and see where it is no longer performing to
expectations and make sure that the weak points are addressed with the new
hardware. If an upgrade from 5 to 6 is also happening make sure the new system
addresses the change in DB.
In my case the p5's are losing the expiration battle, the test runs with 6.2 on
the p6 show great improvement in run time (faster CPU and some 6.2
improvements). I also found my network was staying busy longer during the
backup window, so I doubled the bandwidth. In 2 weeks theory becomes reality.
I am sure your situation is different, but I hope this helps. Others may have
additions or other ideas.
Andy Huebner
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Ballenger, Craig
Sent: Tuesday, May 01, 2012 3:08 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: [ADSM-L] Tivoli Server Specs
Please see below...
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT vm.marist DOT edu] On Behalf Of
Huebner,Andy,FORT WORTH,IT
Sent: Tuesday, May 01, 2012 10:38 AM
To: ADSM-L AT vm.marist DOT edu
Subject: Re: [ADSM-L] Tivoli Server Specs
A few details would help.
1. How many nodes - 380
2. How much data (total & daily) - not sure, but the DB is 256 GB on the
largest TSM instance.
3. Deduplication - No dedup.
I have a pair of P7s with 32GB RAM that are running great. I have 4 P5s that
are a bit overloaded that will be upgraded to P6 with 32GB RAM. No dedup and
about 4,000 nodes total.
Andy Huebner
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Ballenger, Craig
Sent: Tuesday, May 01, 2012 9:15 AM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: [ADSM-L] Tivoli Server Specs
All,
I am attempting to spec out a server(s) for TSM 6 and were wondering what
hardware you folks are running it on. We were looking at the Power Series from
IBM (POWER6/POWER7). Any info will help.
Thanks,
Craig Ballenger
This e-mail (including any attachments) is confidential and may be legally
privileged. If you are not an intended recipient or an authorized
representative of an intended recipient, you are prohibited from using, copying
or distributing the information in this e-mail or its attachments. If you have
received this e-mail in error, please notify the sender immediately by return
e-mail and delete all copies of this message and any attachments.
Thank you.
This e-mail (including any attachments) is confidential and may be legally
privileged. If you are not an intended recipient or an authorized
representative of an intended recipient, you are prohibited from using, copying
or distributing the information in this e-mail or its attachments. If you have
received this e-mail in error, please notify the sender immediately by return
e-mail and delete all copies of this message and any attachments.
Thank you.
|
|
|