TSM 5.5 on AIX.

I'm freeing up some (primary) disk storage pool volumes out of mostly
empty pools on old TSM servers, in order to free up the volume groups and
raw logical volumes and LUNs.

I've been setting the disk storage pool volumes to access=readonly and
then using the "move data" command to empty them back into the same pool.

Occasionally, once a move data has completed successfully, a particular
volume will not be deletable via "del vol" as it still contains some data.

(Running an audit vol shows that 7 files remain.)

Cycles of  successful "move data" don't clear the volume. (I've also tried
these steps with the volume set to access=readw ) Waiting a while and
trying the cycle again, sometimes does work, but not in this case.

Any tips? Does anyone know a method or trick for getting the last objects
to move?

Thanks,
[RC]
U.S. BANCORP made the following annotations
---------------------------------------------------------------------
Electronic Privacy Notice. This e-mail, and any attachments, contains 
information that is, or may be, covered by electronic communications privacy 
laws, and is also confidential and proprietary in nature. If you are not the 
intended recipient, please be advised that you are legally prohibited from 
retaining, using, copying, distributing, or otherwise disclosing this 
information in any manner. Instead, please reply to the sender that you have 
received this communication in error, and then immediately delete it. Thank you 
in advance for your cooperation.



---------------------------------------------------------------------