Stef,

Thanks for the suggestion. The iocp has been enable and it is available but 
still installation failed with same error (SEVERE : Aborting installer: Content 
is not allowed in prolog. )

It is unbelievable to see no improvement on the installation of the pkg after 
almost a year since 6.1 release. 

Pawlos

-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of 
Stef Coene
Sent: Saturday, June 19, 2010 12:24 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: [ADSM-L] TSM 6.2 server AIX installation issue

On Saturday 19 June 2010, you wrote:
> Iocp fileset is installed on system , I will try installing X11 
> fileset and try reinstalling the tsm server again
You also have to 'enable' iocp.  You can check it with 'lsdev -C | grep iocp'.
The iocp0 device should have status Available.


<rant>
I don't know how it is possible that a good product likt TSM 5 (and before) can 
be changed in a monster like TSM6.

TSM 5.5:
du -ms /usr/tivoli/tsm/server/bin/dsmserv
20.03  /usr/tivoli/tsm/server/bin/dsmserv

TSM 6.1:
du -ms /opt/tivoli/tsm
2118.44 /opt/tivoli/tsm

Euh, from 20MB to 2 GB ???

I can understand the need to 'upgrade' the database to db2, but if this also 
means the it is almost impossible to debug the installation process, the 
upgrade process, the initialization process and the daily problems, give me 
back the old non-db2 backend !!!
</rant>


Funny, I just checked my running TSM 6.1.3.1 server and iocp is 'Defined'.  So 
why do I need to install iocp if it is not needed ?
lsdev -C| grep iocp
iocp0         Defined                 I/O Completion Ports


Stef