We are using the 8100 because it is here.
The 8100 is shared across the mainframe. z/os for all administrative data,
db2, vsam etc. All z/os backups ar done to tape as well. However, the
university is getting an ERP solution, and the remaining candidates are
sunguard banner, and peoplesoft. Finally, there is a distinct anti-mainframe
wind blowing here. I give it five years tops.
Gary Lee
Senior System Programmer
Ball State University
phone: 765-285-1310
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Remco Post
Sent: Monday, June 14, 2010 12:12 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: [ADSM-L] Questions about vtl useage
Hi,
On 14 jun 2010, at 14:54, Lee, Gary D. wrote:
> Tsm server v5.5.4 running on suse sles9 under zvm 5.3.
>
> We are in need of expanding our storage. Currently have an ibm 8100. The
> disk is cheap enough, but the licensing for additional storage is outrageous.
>
I'd say that a ds8100 is way overkill for TSM usage. DS5000 is way more
suitable, and a lot less expensive.
> We are thinking of switching to using a vtl for onsite storage and doing away
> with our onsite tape.
>
Tape has one advantage: idle tapes are almost cost-free. Idle data sitting on
disk still consumes power. Of course, if the amount of data is small enough
(few TB) a disk-only solution makes sense. And of course, if your DR
requirements are that you need access to first byte to be less than a second....
> Are any folks out there using vtl, and if so what kinds and what has been
> your experience?
>
> I currently have about 3 tB of onsite tape, looking to at least double that
> when we pick up the exchange 2007 environment.
>
3 TB is peanuts. I'd say, buy a DS3000 (or comparable) dedicated to TSM. Will
be way cheaper than any VTL solution. BTW, where do you keep the backups of all
other data on your ds8100?
> Thanks for any information.
>
>
> Gary Lee
> Senior System Programmer
> Ball State University
> phone: 765-285-1310
>
--
Met vriendelijke groeten/Kind Regards,
Remco Post
r.post AT plcs DOT nl
+31 6 248 21 622
|