On Feb 26, 2010, at 11:33 AM, Mario Behring wrote:
> Hi list,
>
> I am getting the following error on one of my drives when performing a MOVE
> DATA:
>
> ANR8302E I/O error on drive DRIVE01 (MT4.0.0.3) with
> volume (OP=OFFL, Error Number=1, CC=0, rc = 1, KEY=05,
> ASC=53, ASCQ=02, SENSE=70.00.05.00.00.00.00.58.00.00.00.-
> 00.53.02.30.00.2C.19.00.00.00.01.32.30.30.30.32.36.4C.00-
> .00.00.00.00.04.00.00.00.00.04.81.1B.60.00.00.00.00.00.0-
> 5.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.-
> 00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00-
> .30.38.39.4C.31.31.33.39.37, Description=An undetermined
> error has occurred). Refer to Appendix C in the
> 'Messages' manual for recommended action. (SESSION: 1,
> PROCESS: 2)
Did you pursue the codes in the Messages manual? They tell of a llegal request
/ medium removal prevented condition. This may resolve to a device driver
issue, as previously outlined in postings on this library. If one tape drive
is working fine but not the other, check the firmware levels on them, where the
problem one may well be at a lower level. A firmware defect can result in
timing issues, such that a tape dismount may be rejected as too early in a
mechanical/electronic process. Also double-check element numbers to assure
that the drive is being addressed correctly. You may want to exercise the
drive via NTUTIL or the like, to verify functionality.
Richard Sims
|