Hi Jane,
I normally don't use or turn on SANDiscovery on Linux 86_64 and x86 because of
that reason, it normally don't work. I sow a article on IBM website where you
need to copy a library file to /opt/tivoli/tsm/server/bin or something like
that but it never worked.
One thing that pops up in my head when I reading your email is MPIO to your
library? Do you have multiple paths to your Tape Drives? And have you turned on
MPIO (MPATH)
Best Regards
Christian Svensson
Cell: +46-70-325 1577
E-mail: Christian.Svensson AT cristie DOT se
Skype: cristie.christian.svensson
________________________________________
Från: ADSM: Dist Stor Manager [ADSM-L AT VM.MARIST DOT EDU] för janecb01
[tsm-forum AT BACKUPCENTRAL DOT COM]
Skickat: den 17 september 2009 21:42
Till: ADSM-L AT VM.MARIST DOT EDU
Ämne: RHEL5-2.6.18.96 - Lin_tape 1.24-Sandiscovery wont work
Hi,
I have compiled the latest Lin_tape and installed lin_taped on my Linux RHEL5
server.. I am using a Netapp Nearstor VTL emulating IBM LTO4 drives.
Sandiscovery will not work, and at best will crash the system every few hours
or so unless it is turned off - / or set to PASSIVE. When I scan the system,
the drives are dicovered and connected to the lin_tape driver:
lin_tape: detected device at host 1, channel 0, id 0, lun 1
IBM ULTRIUM-TD4 022C
lin_tape: successfully attached IBMtape0
lin_tape: detected device at host 1, channel 0, id 0, lun 2
IBM ULTRIUM-TD4 022C
lin_tape: successfully attached IBMtape1
lin_tape: detected device at host 1, channel 0, id 0, lun 3
but as soon as tapes start loading we get various errors:
lin_tape: IBMtape20----51868 tape_logsense_page() unable to do log sense
lin_tape: IBMtape20----51868 tape_logsense_page() unable to do log sense
lin_tape: IBMChgr1-----80401 changer_check_result() sensekey: 6 asc: 28 ascq: 0
lin_tape: IBMtape19----b4fb0 tape_set_all_parms() unable to change recovery
timeouts
The crashing has become very annoying - IBM recommends a QLogic hba driver that
is not supported by QLogic or RHEL5 (8.01.06) We have 8.02.23 - but that might
not be related.
IBM has been studying the information for a while now.. but this is getting
very frustrated. The lin_tape compiled without error for my kernel.
Sandiscovery will not adjust the devices as it does on AIX perfectly..
Any suggestions or help would be greatly appreciated.
Jane
+----------------------------------------------------------------------
|This was sent by jane_c_bamberger AT keybank DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
|