Last use columns will reamin blank in this case until the volume is actually 
used for something. The TSM database still contains all the information as to 
scratch, non-scratch data, and non-scratch dbbackup volumes.

Forcing a LABEL LIBV command on the tapes will wipe out all the data that they 
contain.

--
Mark

-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of 
Larry Peifer
Sent: Thursday, January 29, 2009 7:07 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: [ADSM-L] What did I miss

Just went through a tape library swap out but ran into a problem with
getting the tsm server to see the tape library volumes.    Deleted and
added back the library, drives and paths in TSM.  The new library is a
duplicate match of the old one.  So we took all of the tapes from old and
put them into new.   The tms data base and all other components remained
the same.  What method should be used to have tsm read in the library
volumes so it knows what tapes are scratch or have data or are the
dbbackup?  I tried 'audit library' and 'checkin libvol' for both scratch
and private but 'q libvol' never showed 'Last Use' as Data, or Dbbackup.

Also,  what is the command for keeping the dsmserv from starting up and
immediately starting it's admin jobs?

Thanks in advance.

No virus found in this incoming message.
Checked by AVG. 
Version: 7.5.552 / Virus Database: 270.10.15/1922 - Release Date: 1/28/2009 
7:24 PM
 

No virus found in this outgoing message.
Checked by AVG. 
Version: 7.5.552 / Virus Database: 270.10.15/1922 - Release Date: 1/28/2009 
7:24 PM