Re: [ADSM-L] Adic fastor2
2007-12-31 04:17:24
NB: This email and its contents are subject to our email legal notice
which can be viewed at http://www.sars.gov.za/Email_Disclaimer.pdf
----
Good day all
Please note that the hardware was replaced and the problem resolved. It
seems as though the barcode reader was coursing the problem.
Thanks for the responds.
Regards
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Richard Sims
Sent: 25 December 2007 04:51 PM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: [ADSM-L] Adic fastor2
On Dec 25, 2007, at 7:25 AM, Hamilton Kungoane wrote:
> I am battling to get the adic fastor 2 tape library working on TSM, my
> configuration is as follows
>
> Tsm server version 5.3.4 on windows 2003 standard edition
>
> Adic fastor 2 Libray firmware S44R and drive firmware 1702
I think you mean ADIC FastStor 2.
Your posting doesn't say anything about the all-important driver you
are using with the library and drives. Make sure you are adhering to
the information provided on the Web page "Supported devices for AIX,
HP, SUN and Windows",
http://www-306.ibm.com/software/sysmgmt/products/support/IBM_TSM_Support
ed_Devices_for_AIXHPSUNWIN.html
as linked from the TSM Support Page
http://www-306.ibm.com/software/sysmgmt/products/support/IBMTivoliStorag
eManager.html
Assure that you are employing a 32- or 64-bit driver which matches
your operating system, according to the IBM information. And always
test that the library and drive are functional at the operating system
level before trying to use with TSM: if it doesn't work at the OS
level, it sure isn't going to work in TSM.
When using the TSM device driver, you can test with the 'lbtest'
command (see Technote 1049959); and there is the 'ntutil' command.
Richard Sims
|
|
|