I have the same issue with a few volumes. they are at 0.1 % utilized but
a move data says there is no data on the volumes and a del vol says the
volume can't be deleted because it conatins data. The discard=yes should
delete it though. I haven't done that yet as I was trying to find a
solution as well.

>>> contains AT GRHOSP.ON DOT CA 10/9/2007 2:55 PM >>>
Hello TSM's,



I have a copypool volume with nothing on it, meaning q content - no
data. When I try to #delete volume xxxxxxx discarddata=yes - it
returns
- volume contains data. When I use move data - it returns - volume
contains no data. DRM says it is in vault status.



I would like to make this volume as scratch and put it back into the
scratch pool. Any suggestions?



Regards,



Kamran H. Rao


IMPORTANT NOTICE:  This message and any included attachments are from East 
Jefferson General Hospital, and is intended only for the addressee(s), and may 
include Protected Health (PHI) or other confidential information.  If you are 
the intended recipient, you are obligated to maintain it in a secure and 
confidential manner and re-disclosure without additional consent or as 
permitted by law is prohibited.   If you are not the intended recipient, use of 
this information is strictly prohibited and may be unlawful.  Please promptly 
reply to the sender by email and delete this message from your computer. East 
Jefferson General Hospital greatly appreciates your cooperation.