Hmmm... I hate when this happens....
I found the wishdom... It was written (by myself) in the course-book ADSM
3.1 Basics... :-s
So, my excuses to everyone...
Regards,
Maurice
----- Original Message -----
From: "Andrew Raibeck" <storman AT US.IBM DOT COM>
To: <ADSM-L AT VM.MARIST DOT EDU>
Sent: Wednesday, August 31, 2005 4:47 PM
Subject: Re: [ADSM-L] @Developers: Need maintenance releases? - was: Re:
[ADSM-L] Upgrade strategy - was "GetBootPath: error on QueryDosDevice()"
> I'm not aware that there was ever a requirement for a base-level install,
> at least for the regular backup-archive clients (not sure about TDPs, at
> the least, there might be a base-level install required for the license).
> If you are referring to the the backup-archive client, do you have a
> specific example you can point to that illustrates when the README
> indicated otherwise?
>
> Regards,
>
> Andy
>
> Andy Raibeck
> IBM Software Group
> Tivoli Storage Manager Client Development
> Internal Notes e-mail: Andrew Raibeck/Tucson/IBM@IBMUS
> Internet e-mail: storman AT us.ibm DOT com
>
> The only dumb question is the one that goes unasked.
> The command line is your friend.
> "Good enough" is the enemy of excellence.
>
> "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU> wrote on 2005-08-31
> 06:11:33:
>
> > Dear Developer,
> >
> > In the readme's of the clients there is no requirements anymore for a
> > base-level installation of the client.
> > Does that mean it's always safe to install a patch-release of a client
> > without the maintenance release?
> >
> > Thanks in advance,
> > Maurice van 't Loo
> >
> >
> > ----- Original Message -----
> > From: "Henrik Wahlstedt" <SHWL AT STATOIL DOT COM>
> > To: <ADSM-L AT VM.MARIST DOT EDU>
> > Sent: Tuesday, August 30, 2005 6:33 PM
> > Subject: Re: [ADSM-L] Upgrade strategy - was "GetBootPath: error on
> > QueryDosDevice()"
> >
> >
> > Hum...
> >
> > Exactly where? I havent had time to set my brain to TSM mode after three
> > weeks of vacation. But as far as I remember I
> > never had any problems what so ever installing a patch, witout
> > installing 5.x.y.0 first.
> > ftp://service.boulder.ibm.com/storage/tivoli-storage-management/maintena
> > nce/client/v5r1/Windows/WinNT/v516/IP22660_READ1STC.TXT
> >
> > ftp://service.boulder.ibm.com/storage/tivoli-storage-management/patches/
> > client/v5r1/Windows/WinNT/v516/IP22660_6_READ1STC.TXT
> >
> > -H.
> >
> >
> > -----Original Message-----
> > From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On
> > Behalf Of
> > Maurice van 't Loo
> > Sent: 30. august 2005 16:42
> > To: ADSM-L AT VM.MARIST DOT EDU
> > Subject: Re: Upgrade strategy - was "GetBootPath: error on
> > QueryDosDevice()"
> >
> > It's in the readme....
> >
> > ----- Original Message -----
> > From: "Henrik Wahlstedt" <SHWL AT STATOIL DOT COM>
> > To: <ADSM-L AT VM.MARIST DOT EDU>
> > Sent: Tuesday, August 30, 2005 4:26 PM
> > Subject: [ADSM-L] Upgrade strategy - was "GetBootPath: error on
> > QueryDosDevice()"
> >
> >
> > No problem and I agree.
> > I have never read anything about the client base level requirement
> > before installing a patch on a Windos client.
> > Where did you find that information?
> >
> > //Henrik
> >
> > -----Original Message-----
> > From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On
> > Behalf Of
> > Maurice van 't Loo
> > Sent: den 30 augusti 2005 15:51
> > To: ADSM-L AT VM.MARIST DOT EDU
> > Subject: Re: GetBootPath: error on QueryDosDevice()
> >
> > Yes, sorry...
> > 5.1.5 was a baselevel also... That was a very strange releasenumber....
> > I think it should be 5.2... but hey, my meaning is that 5.3 should be
> > 6.1... i don't understand the versions completely....
> >
> > But normaly the full versions are x.x.0.0 for servers and x.x.x.0 for
> > clients.
> >
> > Regards,
> > Maurice
> >
> > ----- Original Message -----
> > From: "Henrik Wahlstedt" <SHWL AT STATOIL DOT COM>
> > To: <ADSM-L AT VM.MARIST DOT EDU>
> > Sent: Tuesday, August 30, 2005 3:20 PM
> > Subject: Re: [ADSM-L] GetBootPath: error on QueryDosDevice()
> >
> >
> > Hi Maurice,
> >
> > As far I remember it is 5.1.5 that i base level for 5.1.9 server.
> > And is that true, that I really need to install "base level" before I
> > apply a patch on a client?
> >
> > //Henrik
> >
> >
> >
> > -----Original Message-----
> > From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On
> > Behalf Of
> > Maurice van 't Loo
> > Sent: den 30 augusti 2005 13:23
> > To: ADSM-L AT VM.MARIST DOT EDU
> > Subject: Re: GetBootPath: error on QueryDosDevice()
> >
> > Hi Hendrik,
> >
> > I see that use version 5.1.6.6 client.
> > Did you installed the right version? You cannot use this version without
> > the base version 5.1.6 installed first.
> >
> > You don't get any error when you install it, but it can give very
> > strange problems when using.
> >
> > Same for the server: first 5.1.0.0, then 5.1.9.0, then a patchlevel when
> > needed.
> >
> > Regards,
> > Maurice
> >
> >
> >
> > > -----Original Message-----
> > > From: Henrik Wahlstedt [mailto:SHWL AT STATOIL DOT COM]
> > > Sent: Tuesday, August 30, 2005 12:32
> > > To: ADSM-L AT VM.MARIST DOT EDU
> > > Subject: GetBootPath: error on QueryDosDevice()
> > >
> > >
> > > Hello,
> > >
> > > I wonder what this error mean and why I get it? After googling for
> > > GetBootPath and QueryDosDevice() but with no luck. I have found
> > > similar questions on list but no answers. Do anyone have any idea what
> > this is?
> > >
> > > 29-08-2005 20:06:19 GetBootPath: error on QueryDosDevice() for C:\, rc
> >
> > > = 998
> > > 29-08-2005 20:06:19 GetBootPath: error on QueryDosDevice() for E:\, rc
> >
> > > = 998
> > > 29-08-2005 20:06:19 Boot path was not found. Assumed
> > boot
> > > path as C:\
> > >
> > > 5.1.6.6 Windows client and 5.1.9 server.
> > >
> > >
> > > //Henrik
> > >
> > >
> > > -------------------------------------------------------------------
> > > The information contained in this message may be CONFIDENTIAL and is
> > > intended for the addressee only. Any unauthorised use, dissemination
> > > of
> > the
> > > information or copying of this message is prohibited. If you are not
> > > the addressee, please notify the sender immediately by return e-mail
> > > and
> > delete
> > > this message.
> > > Thank you.
> > >
> > >
> > > **********************************************************************
> > > For information, services and offers, please visit our web site:
> > http://www.klm.com. This e-mail and any attachment may contain
> > confidential and privileged material intended for the addressee only. If
> > you are not the addressee, you are notified that no part of the e-mail
> > or any attachment may be disclosed, copied or distributed, and that any
> > other action related to this e-mail or attachment is strictly
> > prohibited, and may be unlawful. If you have received this e-mail by
> > error, please notify the sender immediately by return e-mail, and delete
> > this message. Koninklijke Luchtvaart Maatschappij NV (KLM), its
> > subsidiaries and/or its employees shall not be liable for the incorrect
> > or incomplete transmission of this e-mail or any attachments, nor
> > responsible for any delay in receipt.
> > > **********************************************************************
> > >
> >
> >
> > -------------------------------------------------------------------
> > The information contained in this message may be CONFIDENTIAL and is
> > intended for the addressee only. Any unauthorised use, dissemination of
> > the information or copying of this message is prohibited. If you are not
> > the addressee, please notify the sender immediately by return e-mail and
> > delete this message.
> > Thank you.
> >
> >
> > -------------------------------------------------------------------
> > The information contained in this message may be CONFIDENTIAL and is
> > intended for the addressee only. Any unauthorised use, dissemination of
> > the information or copying of this message is prohibited. If you are not
> > the addressee, please notify the sender immediately by return e-mail and
> > delete this message.
> > Thank you.
> >
> >
> > -------------------------------------------------------------------
> > The information contained in this message may be CONFIDENTIAL and is
> > intended for the addressee only. Any unauthorised use, dissemination of
> the
> > information or copying of this message is prohibited. If you are not the
> > addressee, please notify the sender immediately by return e-mail and
> delete
> > this message.
> > Thank you.
>
|
