Re: Trouble - ASR on Win2003 - changed raid controller

Hi,

What I used when I tested to do a restore to a different RAID controller
was to use a slip streamed w2k3 installation CD where all HP drivers
were included. I had no problems and it should work if you follow the
steps in the ASR Redbook.

HP DL380 G3,  5i Plus and 5312 controler. 
Backup 5i       -> Restore  5i  OK
Backup 5i       -> Restore  5312        OK
Backup 5312     -> Restore  5312        OK
Backup 5312     -> Restore  5i  OK 

//Henrik

-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Gottfried Scheckenbach
Sent: den 13 juni 2005 14:01
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Trouble - ASR on Win2003 - changed raid controller

Hi all,

does somebody know if asr recovery is possible in this case? ASR
diskette and backupsets are ready!

Do I have to change the asr disk to have the new driver included?

>From my point of view:

1. Boot and Install from backupsets should be no problem
   because driver can be supplied in fist - nongraphics - boot phase

2. Boot of the installed System is the real problem
   because without changing the asr disk there is no driver to
   open the new raid controller

Thanks,
Gottfried


-------------------------------------------------------------------
The information contained in this message may be CONFIDENTIAL and is
intended for the addressee only. Any unauthorised use, dissemination of the
information or copying of this message is prohibited. If you are not the
addressee, please notify the sender immediately by return e-mail and delete
this message.
Thank you.