Re: Where did my scratch tapes go?
2004-11-05 14:07:51
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On
Behalf Of Nancy L Backhaus
>2 libraries - one scratch count is steady, my LTOLIB library
>scratch count is too low, privates too high.
>
>What is happening? Where do I begin looking?
You've asked a very wide-open question. Try this first: run
checkin libv <library_name> search=yes status=scratch checkl=no
followed by
checkin libv <library_name> search=yes status=private checkl=no
followed by
audit library <library_name> checkl=barcode
(The syntax for the CHECKIN commands may vary, depending upon the type
of library you have. Do not run the AUDIT command while any other tape
operations are running.)
Now run your tape counts again. See what they say.
--
Mark Stapleton (stapleton AT berbee DOT com)
Berbee Information Networks
Office 262.521.5627
|
|
|