ADSM-L

Re: How to setup GUI to access NDMP TOC for DAR?

2004-07-15 15:02:24
Subject: Re: How to setup GUI to access NDMP TOC for DAR?
From: Robert Clark <raclark AT REGENCE DOT COM>
To: ADSM-L AT VM.MARIST DOT EDU
Date: Thu, 15 Jul 2004 12:01:47 -0700
Thanks Karel.

Even when correctly configured, the BA client GUI doesnt' do the job.

Only starting the "client acceptor service" (on my W2K laptop) and
connecting via a browser (to http://localhost:1581/) does the job.

Thanks, [RC]





                      "Bos, Karel"
                      <Karel.Bos@ATOSORIGIN       To:    ADSM-L AT VM.MARIST 
DOT EDU
                      .COM>                      cc:
                      Sent by: "ADSM: Dist       Subject:      Re: How to setup 
GUI to access NDMP TOC for DAR?
                      Stor Manager"
                      <ADSM-L AT VM.MARIST DOT EDU
                      >


                      07/14/2004 12:22 AM
                      Please respond to
                      "ADSM: Dist Stor
                      Manager"

                      |-------------------|
                      | [ ] Secure E-mail |
                      |-------------------|





Hi,

Never seen the BA client GUI being able to display the NAS TOC, but the WEB
client will do the trick.

Regards,

Karel

-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU]On Behalf Of
Robert Clark
Sent: woensdag 14 juli 2004 01:47
To: ADSM-L AT VM.MARIST DOT EDU
Subject: How to setup GUI to access NDMP TOC for DAR?


I've been testing NDMP backups using the datamover of an EMC Celerra
writing to a SAN attached 3494.

I needed to read between the lines in the docs a bit to figure out to set
it up, but its working.

But I don't see any info on how to setup a W2K B-A GUI so that it will read
the TOC(table of contents) and allow for DAR(direct access restore) of the
Celerra. (This seems to be how it needs to work, based on reading the
current "TSM Admin Guide (for AIX)".)

Do I need the "NAS" portion of the B-A client installed, even though the
system I have the W2K GUI on doesn't have access to the NAS portion of the
Celerra?

I've added a "nasnode" line to the dsm.opt, but the client still doesn't
show an entry for the Celerra in the GUI.

Any hints or pointers to pertinent docs appreciated.

Thanks, [RC]


==============================================================================

IMPORTANT NOTICE: This communication, including any attachment, contains
information that may be confidential or privileged, and is intended solely
for the entity or individual to whom it is addressed.  If you are not the
intended recipient, you should delete this message and are hereby notified
that any disclosure, copying, or distribution of this message is strictly
prohibited.  Nothing in this email, including any attachment, is intended
to be a legally binding signature.
==============================================================================






==============================================================================
IMPORTANT NOTICE: This communication, including any attachment, contains 
information that may be confidential or privileged, and is intended solely for 
the entity or individual to whom it is addressed.  If you are not the intended 
recipient, you should delete this message and are hereby notified that any 
disclosure, copying, or distribution of this message is strictly prohibited.  
Nothing in this email, including any attachment, is intended to be a legally 
binding signature.
==============================================================================

<Prev in Thread] Current Thread [Next in Thread>