Antwort: Restore Volume Problems
2004-03-10 05:23:04
If there is no copy of the volumedata stored on a copy storage pool, you
cannot restore the volume because there is no alternative data source.
Check the difference between your primary storage pool and your copy
storage pool.
Every time i have such a problem, I set the tape to unavailable and wait
till the tape gets less utilized.
Then i check the importance of the data left on the tape. If there are no
important files left, I simply delete the tape (with "discarddata=yes").
If there are any other solutions, I also would appreciate to hear them!
Best regards
Patrick Rainer
David Benigni <dbenigni AT LUTRON DOT COM>
Gesendet von: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
10.03.2004 03:30
Bitte antworten zu
"ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
An
ADSM-L AT VM.MARIST DOT EDU
Kopie
Thema
Restore Volume Problems
Recently I had a tape get destroyed in a tape drive. I did the typical
procedure in the Tivoli Admin Manual to restore the volume.
All the tapes specified in the restore vol xxxxx prev=yes where brought
on site. However after we did the restore I got a warning "ANR1256W"
regarding some files couldn't be restored. Doing a restore vol xxxxx
prev=yes doesn't show any volumes that are needed to restore it.
Reclamation has not occured since the tape was destroyed. The tape is
beyond repair and can't do a move data from it.
Has anyone run across this? Any recommendations?
TIA
Dave
|
|
|