ADSM-L

Re: Cartridge Estimated capacity

2004-01-22 12:05:41
Subject: Re: Cartridge Estimated capacity
From: Charlie Hurtubise <charlieh AT TECSYS DOT COM>
To: ADSM-L AT VM.MARIST DOT EDU
Date: Thu, 22 Jan 2004 12:04:11 -0500
Hello. Timely subject for me as I have just begun using LTO-2s and LTO-1s. I
was a big DLT users for years, still am but not with Tivoli.

Note.. assuming of course, one must remember that if you are compressing the
Tivoli backup data on disk, when it gets to tape, even if you are
compressing on tape, the tape won't compress very much???

Then on this note, I am curious why when I defined my LTO-2 and LTO-1 tape
types, I specified LTO2C and LTO1C which should compress up to 400 GIGs for
an LTO2 and 200 GIGs for an LTO1. But my q vol shows 200 GIGs and 100 GIGs
used at FULL. Anyone else see this or comment.

Tks
Charlie H
Tecsys Inc.



-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU]On Behalf Of
David Longo
Sent: Thursday, January 22, 2004 11:56 AM
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: Cartridge Estimated capacity


Relatively simple.  The "EST CAP" is set when you define the DEVCLASS,
probably 80GB in this case (see line for tape 000034).  When data is then
writtent to the tape, the EST Cap is updated to the ACTUAL capacity
when the tape gets FULL.  This may be higher or lower than the value
in the defioned devclass.

The tape will show the original EST Cap while FILLING until the amount
of data exceeds this value.  Then it increases as data is added
until tape is FULL.

The tapes that show FULL but have a pct Util less than 100 are
mostly tapes had some of the data expired since they became FULL.


David B. Longo
System Administrator
Health First, Inc.
3300 Fiske Blvd.
Rockledge, FL 32955-4305
PH      321.434.5536
Pager  321.634.8230
Fax:    321.434.5509
david.longo AT health-first DOT org


>>> rouzen AT UNIV.HAIFA.AC DOT IL 01/22/04 11:45AM >>>
Hi to all

Can anybody tell me why the huge difference between  the numbers of
Estimated Capacity  of a full cartidge DLT8000 (40/80 G). The format of the
devclass was configure to DRIVE.
The nodes are backup without compression .

Here the output of the q vol.

Volume Name               Storage      Device      Estimated    Pct   Volume
                          Pool Name    Class Name   Capacity   Util   Status
                                                        (MB)
------------------------  -----------  ----------  ---------  -----
--------
000002                    SCA_UNIX     SCALARCLA-   58,089.8   96.5    Full
                                        SS
000009                    SCA_UNIX     SCALARCLA-  165,222.0   64.6    Full
                                        SS
000016                    SCA_UNIX     SCALARCLA-   76,230.3   49.1    Full
                                        SS
000027                    SCA_UNIX     SCALARCLA-   65,272.7   40.9    Full
                                        SS
000034                    SCA_UNIX     SCALARCLA-   80,000.0    3.9  Filling
                                        SS
000044                    SCA_UNIX     SCALARCLA-  136,684.2   62.8    Full
                                        SS
000111                    SCA_UNIX     SCALARCLA-   48,768.3   44.5    Full
                                        SS
000141                    SCA_UNIX     SCALARCLA-   51,704.7   40.6    Full
                                        SS
000158                    SCA_UNIX     SCALARCLA-   70,574.6   97.3    Full
                                        SS
000159                    SCA_UNIX     SCALARCLA-   80,000.0   62.9  Filling

T.I.A Regards
Robert Ouzen
E-mail: rouzen AT univ.haifa.ac DOT il

##############################################################
This message is for the named person's use only.  It may
contain confidential, proprietary, or legally privileged
information.  No confidentiality or privilege is waived or
lost by any mistransmission.  If you receive this message
in error, please immediately delete it and all copies of it
from your system, destroy any hard copies of it, and notify
the sender.  You must not, directly or indirectly, use,
disclose, distribute, print, or copy any part of this message
if you are not the intended recipient.  Health First reserves
the right to monitor all e-mail communications through its
networks.  Any views or opinions expressed in this message
are solely those of the individual sender, except (1) where
the message states such views or opinions are on behalf of
a particular entity;  and (2) the sender is authorized by
the entity to give such views or opinions.
##############################################################

<Prev in Thread] Current Thread [Next in Thread>