actually I just did a migration from 4 3590B to 6 3590E
You do not have to change access on all tapepool tapes to read-only, only the
ones with the status of FILLING although doing it to the entire pool will not
cause any problems. you will however have to move the data from the filling
volumes to new volumes using the move data command as TSM does not reclaim
space from tapes in the primary sequential pool in the filling mode.
I checked out all the scratch and then checked them back in just to be safe.
>>> fminns AT WILEY.CO DOT UK 11/05/03 10:14AM >>>
Hi again all
TSM 5.1.6.2 on Solaris 2.7
Tomorrow we are having our B1A drives upgraded to H1A (housed in a 3494
library). Once this has been done, I understand that I will need to mark
all TAPEPOOL volumes as readonly (see prev post), but can I assume that I
need to relable all the scratch tapes that are in the lib at present, so
that they use the new formatting?
Many thanks again
All the best
Farren Minns - John Wiley & Sons
*****************************************************************************
This email transmission is confidential and intended for the person or
organisation it is addressed to. If you are not the intended recipient, you
must not copy, distribute, or disseminate the information, open any
attachment, or take any action in reliance of it. If you have received this
message in error please notify the sender.
Any views expressed in this message are those of the individual sender,
except where the sender specifically states otherwise.
Although this email has been scanned for viruses you should rely on your
own virus check, as the sender takes no responsibility for any damage
arising out of any bug or virus infection.
*****************************************************************************
|