Hi Bruce,

you can still use the Pick-List with the -pick option.
It's maybe a time-consuming task to scroll the pick list
on the command line, when there a lot of directories in
your volumes root, but it should work.

  load dsmc res vol1:\ -pick -subdir=yes -rep=all -tapep=no

bye,
Wolfgang Bayrhof




----- Original Message -----
From: "Kamp, Bruce" <bkamp AT MHS DOT NET>
Date:         Tue, 25 Feb 2003 08:34:05 -0500
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: Netware Restore Question

> I am restoring the whole volume.  It was blown away...  So I can't see the
> directory in any of these utils.  I tried both of your suggestions & no go
> on both...  I also tried vol1:\asset*\ & that didn't work either.  Any other
> suggestions?
>
> --------------------------------------
> Bruce Kamp
> Midrange Systems Analyst II
> Memorial Healthcare System
> E: bkamp AT mhs DOT net
> P: (954) 987-2020 x4597
> F: (954) 985-1404
> ---------------------------------------
>
>
> -----Original Message-----
> From: Wolfgang Bayrhof [mailto:wb AT CONSULTANT DOT COM]
> Sent: Tuesday, February 25, 2003 8:27 AM
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: Re: Netware Restore Question
>
>
> Hi Bruce,
>
> you have to use the short filenames to start the restore operation by the
> command line. The short filenames are saved in the namespace "DOS" under
> NetWare. You can find out the short names by NDIR, MONITOR and NwAdmin.
> Maybe you can also use your Windows Explorer to find out the short names.
>
> The command
>
>   load dsmc res vol1:\assetinv\ -subdir=yes -rep=all -tapep=no
>
> or
>
>   load dsmc res vol1:\assetin1\ -subdir=yes -rep=all -tapep=no
>
> should work.
>
> bye,
> Wolfgang Bayrhof
>
>
> ----- Original Message -----
> From: "Kamp, Bruce" <bkamp AT MHS DOT NET>
> Date:         Tue, 25 Feb 2003 08:03:03 -0500
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: Netware Restore Question
>
> > Environment:
> > TSM client 5.1.5.6 on Netware 6
> > TSM server 5.1.1.6 on AIX 4.3.3
> >
> > Trying to restore the directory vol1:\asset inventory from the command
> > line but can not figure out the correct syntax!  I have tried the
> > following
> > commands:
> > load dsmc res vol1:\asset inventory\ -subdir=yes -rep=all -tapep=no
> > load dsmc res "vol1:\asset inventory\" -subdir=yes -rep=all -tapep=no
> > load dsmc res vol1:\"asset inventory"\ -subdir=yes -rep=all -tapep=no
> > What am I missing?!
> >
> > Thanks,
> > --------------------------------------
> > Bruce Kamp
> > Midrange Systems Analyst II
> > Memorial Healthcare System
> > E: bkamp AT mhs DOT net <mailto:bkamp AT mhs DOT net>
> > P: (954) 987-2020 x4597
> > F: (954) 985-1404
> > ---------------------------------------