Re: checkin command
2003-02-24 17:30:08
It looks like you're trying to check in a single volume. In that case,
you'll need to specify the devtype parameter in your checkin command.
This is what we do to checkin a single tape: checkin libvol 3494A <vol #>
devtype=3590 status=scratch
I'm assuming your 3494 has 3590 drives in it.
Kason Leung
Systems Programmer II
University of California
Office of the President
510-987-0345
E-mail: kason.leung AT ucop DOT edu
At 04:01 PM 2/24/2003 -0600, Tommy Templeton wrote:
Does this command work in a 3494 environment? Does there have to be any
conditions to use it.
The last time I tried to run it, I didn't have very good success. I could
have been doing something wrong.
checkin libvol 3494vts &vol status=scratch
Tommy Templeton
Senior System Administrator
DFA-MMRS
601-359-3106
e-mail - templeton AT mmrs.state.ms DOT us
|
|
|