Hi,
I have exactly the same problem except that I have TSM server on AIX 5.1.
It is very strange, because it happens randomly always during unmounting
the tape.
It is always the same drive - /dev/rmt0.
Tape remains in the drive. I can unload tape using operator panel without
any problem. But if I want to use tapeutil utility I get following error
when I try to open device /dev/rmt0
Operation failed with errno 79: Connection refused
I have to reset SAN Data Gateway and then the drive is again accesible with
tapeutil and also from TSM server.
Does somebody know, what does error message : Operation failed with errno
79: Connection refused
mean? Where I can find information about this error number. I was looking
in Atape driver doc but there is no mention about this message.
In output from errpt there is no error from fibre adapter nor from tape
drive.
Here is copy of Event log from SAN DAta Gateway:
Sequence Time Code Description
0031 FEB 11 2003 08:03:45 110 Health Check 1: Link Status Has
Changed on FCAL 2: linkFail: 0/0, syncLost: 0/0, sigLost: 0/0, primSpErr:
0/0, invWord: 12/0, invCrc: 0/0
0029 FEB 11 2003 08:03:03 70 NOTICE: Reboot Complete
0028 FEB 11 2003 08:02:59 29 Mapping 1: Target Device Added:
index 3, handle 0x091ac308
0027 FEB 11 2003 08:02:59 29 Mapping 1: Target Device Added:
index 2, handle 0x09e68408
0023 FEB 11 2003 08:02:57 29 Mapping 1: Target Device Added:
index 1, handle 0x09ffbe08
0022 FEB 11 2003 08:02:54 28 USCSI 3: Bus RESET
0021 FEB 11 2003 08:02:53 28 USCSI 2: Bus RESET
0016 FEB 11 2003 08:02:52 28 USCSI 1: Bus RESET
0014 FEB 11 2003 08:02:51 29 Mapping 1: Target Device Added:
index 0, handle 0x091b8700
0011 FEB 11 2003 08:02:51 28 USCSI 4: Bus RESET
0010 FEB 11 2003 08:02:51 28 USCSI 3: Bus RESET
0009 FEB 11 2003 08:02:51 28 USCSI 2: Bus RESET
0008 FEB 11 2003 08:02:51 28 USCSI 1: Bus RESET
0057 FEB 11 2003 08:02:20 13 NOTICE: System Shutting Down
0031 FEB 10 2003 03:22:02 110 Health Check 1: Link Status Has
Changed on FCAL 2: linkFail: 0/0, syncLost: 0/0, sigLost: 0/0, primSpErr:
0/0, invWord: 12/0, invCrc: 0/0
0029 FEB 10 2003 03:21:20 70 NOTICE: Reboot Complete
0028 FEB 10 2003 03:21:16 29 Mapping 1: Target Device Added:
index 3, handle 0x091ac408
0027 FEB 10 2003 03:21:16 29 Mapping 1: Target Device Added:
index 2, handle 0x09e68408
0023 FEB 10 2003 03:21:14 29 Mapping 1: Target Device Added:
index 1, handle 0x09ffbe08
0022 FEB 10 2003 03:21:11 28 USCSI 3: Bus RESET
I am not specialist, but in my opinion there is only messages generated
during device rebooting.
Any help appreciated
Ing. Jozef Zatko
Login a.s.
Dlha 2, Stupava
tel.: (421) (2) 60252618
Humberto
Gomez Lopez To: ADSM-L AT VM.MARIST DOT EDU
<hugomez@UCAB cc:
.EDU.VE> Subject: LTO 3583 drive problem.
Sent by:
"ADSM: Dist
Stor Manager"
<ADSM-L AT VM DOT MA
RIST.EDU>
11.02.2003
14:54
Please
respond to
"ADSM: Dist
Stor Manager"
Hi,
I have installed TSM 5.1.6 Server on W2k, and after configuring the
library and the drives and after checking in some tapes succesfully,
Submitting an audit library command I keep getting this error:
02/11/2003 09:37:08 ANR8304E Time out error on drive MT0.12.0.3
(mt0.12.0.3)
in library LB0.7.0.3.
02/11/2003 09:37:08 ANR8912E Unable to verify the label of volume from
slot-element 16 in drive MT0.12.0.3 (mt0.12.0.3) in
library LB0.7.0.3.
02/11/2003 09:37:08 ANR8302E I/O error on drive MT0.12.0.3 (mt0.12.0.3)
(OP=OFFL, Error Number=21, CC=0, KEY=02, ASC=3A,
ASCQ=00,
SENSE=70.00.02.00.00.00.00.1C.00.00.00.00.3A.00.00.00.10-
.13.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.04.0-
0.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.-
00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00-
.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.0-
0.00.00.00.00, Description=An undetermined error
has
occurred). Refer to Appendix D in the 'Messages'
manual
for recommended action.
02/11/2003 09:37:10 ANR8942E Could not move volume NOT KNOWN from
slot-element
256 to slot-element 16.
02/11/2003 09:37:10 ANR9999D mmsscsi.c(9702): ThreadId<34> Volume may
still be
in the drive MT0.12.0.3 (mt0.12.0.3).
02/11/2003 09:37:10 ANR8446I Manual intervention required for library
LB0.7.0.3.
It always happens on the MTO.12.0.3 (the lowest drive), Someone know what
could be happening?
Thanks in advance.
|
