Hi,
Take a look of TSM Device support in IBM support site (you have to be
registered to have full access).
I think you are not using the element numbers defined for your type of library.
I have found the following in IBM support site for ADIC 1000 library.
Tape drive 1 (element 800) __________
Tape drive 2 (element 801) __________
Tape drive 3 (element 802) __________
Tape drive 4 (element 803) __________
Tape drive 5 (element 804) __________
Tape drive 6 (element 805) __________
Tape drive 7 (element 806) __________
Tape drive 8 (element 807) __________
Tape drive 9 (element 808) __________
Tape drive 10 (element 809) __________
Tape drive 11 (element 810) __________
Tape drive 12 (element 811) __________
Hopes this helps,
Rafael
-------
to: fenglimian <fenglimian AT 163 DOT COM>
cc:
date: 1/9/2003 1:49:57 AM
subject: =?GB2312?Q?help=A3=BAdefine automated drive question?=
> Hi all#:
> Today I tried to configure a TSM server!#My lib is ADIC scalar 1000 and
> has two driver#(the elements are 1200#,1201#,I had already made the two
> drives as TSM tape#,devices name are /dev/mt0!"/dev/mt1#)#,after I had
> defined my autolib#,then I tried to define the drives#,everytime I used the
> follow options:
> library name :libname
> drive name:drv1
> device:/dev/mt0
> element:1200
> the output is:Invalid value for ELEMENT parameter.About five months ago,I had
> done the same thing ,every thing is sucessful,what's the problem?
>
>
> !!!!!!!!!!!!!!!!fenglimian
> !!!!!!!!!!!!!!!!fenglimian AT 163 DOT com
> !!!!!!!!!!!!!!!!!!!!2003-01-09
>
_______________________________________________________________________________________________________
Obtin gratis tu cuenta de correo en StarMedia Email. !Regmstrate hoy mismo!.
http://www.starmedia.com/email
|