Hi, Gurus,


My question is when I move data from one volume to another one in same
sequential access pool (LTO), it failed. the target volume is set to
READ-ONLY.
My TSM was 4.2.1/Windows 2000NT. I updated them to 5.1.1.0. But same problem
happened.

Tape0 can archive, retrieve and reclaim.
Any help to tell me what to do
Thanks in advance.

10/24/2002 12:07:30   ANR8302E I/O error on drive GENDRV_TAPE0 (\\.\TAPE0)
                       (OP=WRITE, Error Number=23, CC=0, KEY=03, ASC=53,
                       ASCQ=00,
SENSE=70.00.03.00.00.00.00.1C.00.00.00.00.53.00-

.06.00.31.08.00.00.00.02.00.00.00.00.00.00.00.00.00.00.1-

9.66.04.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.-

00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00-

.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.00.0-
                       0.00.00.00.00.00.00.00, Description=An undetermined
error
                       has occurred).  Refer to Appendix D in the 'Messages'
                       manual for recommended action.
10/24/2002 12:07:30   ANR8359E Media fault detected on LTO volume 291ACTL1
in
                       drive GENDRV_TAPE0 (\\.\TAPE0) of library LB3.0.0.3.
10/24/2002 12:07:30   ANR1411W Access mode for volume 291ACTL1 now set to
                       "read-only" due to write error.