Re: how to add tape to library? (fwd)
2002-10-04 17:53:12
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU]On Behalf Of
Alexander Lazarevich
> I can remove the tapes just fine, but when I try to add a new one,
> per your instructions, here's what happens:
>
> adsm> label libvol ITG-3575 3121cf labelsource=barcode checkin=scratch
> ANR8812E LABEL LIBVOLUME: The SEARCH parameter is required when using
> LABELSOURCE with this command.
> ANS8001I Return code 3.
The problem is that if you specify the volume name, the labelsource
parameter is not necessary.
> So then I add the search parameter and I get this error:
>
> adsm> label libvol ITG-3575 3121cf labelsource=barcode checkin=scratch
> search=bulk
> ANR2020E LABEL LIBVOLUME: Invalid parameter - SEARCH.
> ANS8001I Return code 3.
Okay, here we go:
1. Cancel all processes:
cancel process <process_number>
2. Check for mounted volumes. If there are any, they should all be idle
after all processes are cancelled. Dismount any volume still in a drive:
dismount volume <volume_name>
3. Audit the library:
audit library <library_name> checkl=barcode
4. Open up the library and fill it completely with tapes. Let the library
rehome itself and reset.
5. If they are brand-new tapes (never been used before), run this command:
label libv <library_name> search=yes checkin=scratch labelsource=barcode
overwrite=yes
6. Now run
checkin libv <library_name> search=yes status=scratch checkl=barcode
--
Mark Stapleton (stapleton AT berbee DOT com)
Certified TSM consultant
Certified AIX system engineer
MCSE
|
|
|