ADSM-L

Pre/Post-schedule commands problem

2002-08-14 21:27:11
Subject: Pre/Post-schedule commands problem
From: Rupert Wood <Rupert_Wood AT WESTPACTRUST.CO DOT NZ>
To: ADSM-L AT VM.MARIST DOT EDU
Date: Thu, 15 Aug 2002 13:24:31 +1200
(This is a second try - I can't find an entry for this question after
searching at ADSM.ORG!)

I have successfully managed to run a command sequence (via an Admin Client
GUI) using the form

  -preschedulecmd='pathname1' -postschedulecmd='pathname2'

 , but when testing a "nowait" variant using the form

  -presNchedulecmd='pathname1' -postNschedulecmd='pathname2'

, the client scheduler aborted. I used the above forms as recommended in a
posting on adsm.org.

What have I done wrongly? Our TSM level is 4.2.


Thanks for any help,


Rupert Wood
Technical Specialist
Strategic Outsourcing

IBM (NZ) Ltd.

Telephone: (+64 4) 576-9782 extn. 9782
Fax: (+64 4) 576-5808
e-mail: ruwood AT nz1.ibm DOT com
---------------------------------------------------------------------
The contents of this e-mail are confidential.
If you have received this communication by mistake,
please advise the sender immediately and delete the message and
any attachments.
The views expressed in this e-mail are not necessarily the views of
Westpac Banking Corporation.
Westpac Banking Corporation is incorporated in New South Wales, Australia.
---------------------------------------------------------------------

<Prev in Thread] Current Thread [Next in Thread>