Re: AW: server-to-server copy-pools
2002-06-05 11:35:38
Subject: |
Re: AW: server-to-server copy-pools |
From: |
Zlatko Krastev/ACIT <acit AT ATTGLOBAL DOT NET> |
Date: |
Wed, 5 Jun 2002 18:33:04 +0300 |
Not exactly. Keep in mind that for target server the source one is just a
node of type server. So it depends on domain settings source server node
resides in to which primary pool virtual volumes go. And how many mount
points you have there.
Also you may want more than one mount points in copy pools so generic
formula for mount limit will not be count of copy pools but sum of desired
mount points in pools. Look what Karel wrote.
Zlatko Krastev
IT Consultant
Please respond to "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
Sent by: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
To: ADSM-L AT VM.MARIST DOT EDU
cc:
Subject: AW: server-to-server copy-pools
Thanks,
an additional question before setting up the configuration :
second copy-pool with same device-class means that the data physically go
to
the same tape-pool on the other server, because it works with the default
management-class for that server ( where the pool name is defined). Is
this
correct ?
So the only additional config to make (beneath defining the second
copy-pool) is increasing the 'mount limit' in device-class 'server' on the
one side where copy-pool is defined to the number of copy-pools I define ?
Thanks
Christoph
> -----Ursprüngliche Nachricht-----
> Von: Zlatko Krastev/ACIT [SMTP:acit AT ATTGLOBAL DOT NET]
> Gesendet am: Mittwoch, 5. Juni 2002 07:47
> An: ADSM-L AT VM.MARIST DOT EDU
> Betreff: Re: server-to-server copy-pools
>
> Other server is related not to copy pool but to the device class. You
have
> only to define second pool over same devclass.
>
> Zlatko Krastev
> IT Consultant
>
>
>
>
> Please respond to "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
> Sent by: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU>
> To: ADSM-L AT VM.MARIST DOT EDU
> cc:
>
> Subject: server-to-server copy-pools
>
> Hi all,
>
> today we have two servers connected via server-to-server. Both server
have
> defined their copy-pool on the other server.
> I would like to split the copy-pool into two different ones. Reason is
to
> run stg-pool-backups in more than one session parallel..
> Does anybody know, if this is possible and how I can set up two
different
> copypools on a server, that are accessed via server-to-server connection
> from one other server.
>
> Thanks for any help
>
> Christoph
|
|
|