I have a 'hand me down' 3570-B11, 2 drives, 20 slots, hanging off of an
NT 4 system running TSM 4.1.3.  This unit was previously being used on
an AS400 within this company.

I found 3 sets of drivers for NT on the IBM site, and I downloaded them.
The only one that came near working is IBM Device Drivers 1.1.7.5
for the Magstar.

Now my issues:

1) Is there some special option on the 3570 I need to use it with NT?

2) The system sees the drives, and the library.  But it will not write
on the tapes, or load tapes into the tape drives.

3) The library appears as a 'split' library, with 10 tapes allocated to each
of
the two tape drives, not like a shared library.  I would like to use it
as a single library with 12 slots.

4) The library has a bar code reader in it, but the drivers in NT don't seem
to recognize it.

... These are my troubles.  Any suggestions? .. Thanks ... Jack