Re: ANS0299E when starting NT scheduler service
2002-02-07 09:59:02
If you used the Wizard to setup these services it doesn't quite do it
correctly (APAR= IC32620
ANS0299E SCHEDULE WIZARD SETS SCHEDULE SERVICE TO AUTOMATIC START-UP IN CAD
MANAGED CONFIGURATION
APAR= IC32752 SER=WIZARD AUTOMATIC STARTUP CAD MANAGED SCHEDULER SHOULD
START CAD AFTER THE WIZARD CONFIGURATION)
Check that the services are set as follows:
Schedule Service should be set to manual startup
CAD (Acceptor) Service - should be set to Automatic and started.
Now with this configuration you will still get the following errors in the
Event Log after a reboot:
1:36:49 PM Event ID - 4099. Scheduler Terminated, service ending.
1:36:49 PM Event ID - 4099. Scheduler exited unexpectedly with a result code
of 0.
I've reported these to Tivoli - but no APAR yet on them.
Tim Rushforth
City of Winnipeg
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- ANS0299E when starting NT scheduler service, Aloes consultant
- Re: ANS0299E when starting NT scheduler service,
Rushforth, Tim <=
- Re: ANS0299E when starting NT scheduler service, Malbrough, Demetrius
- Re: ANS0299E when starting NT scheduler service, Andrew Raibeck
- Re: ANS0299E when starting NT scheduler service, Rushforth, Tim
- ANS0299E when starting NT scheduler service, Aloes consultant [mailto:tsmaloes
- Re: ANS0299E when starting NT scheduler service, Aloes consultant [mailto:tsmaloes
- ANS0299E when starting NT scheduler service, Aloes consultant
|
|
|