I've read from some where they said for TSM it's automatically do the
dbupgrade for you...
But my case I was not....
After loaddb/restoredb I need to run dsmserv dbupgrade .... If not the
adsmserver can't be up....

regards,

Thida Chintawongvanich

SAP Infrastructure Support Team (SITI-ISPS/31)
Shell Information Technology International Sdn., Bhd.
___________________________________________________________
2340 Century Square
Jln Ushawan 63000 Cyberjaya, Kuala Lumpur, Malaysia
(Tel : +603 8313 3446 : Fax : +603 251 2788 )
*Personal EMail : T.chintawongvanich AT shell DOT com
*Group EMail : ITS_AsiaPacific AT ssi.shell.com DOT my

 -----Original Message-----
From:   Jim Kirkman [mailto:jmk AT EMAIL.UNC DOT EDU]
Sent:   Tuesday, October 02, 2001 2:24 AM
To:     ADSM-L AT VM.MARIST DOT EDU
Subject:        Re: TSM version changes

Zoltan,

We just applied this version. We simply received and applied the PTF
(UQ56266). It calls in three or four others but is fairly straight
forward. No dbupgrade was required for TSM

Zoltan Forray/AC/VCU wrote:

> What are the guidlines, if any, for when you need to do a DBUPGRADE ?
>
> For instance, I am running OS390 TSM V4.1.3.  I need to put up V4.1.4.
>
> I haven't seen anything (unless I missed it) that says I need to do a
> DBUPGRADE.
>
> ===========================
> Zoltan Forray
> Virginia Commonwealth University
> University Computing Center
> e-mail: zforray AT vcu DOT edu
> voice: 804-828-4807

--
Jim Kirkman
Jim Kirkman
AIS - Systems
UNC-Chapel Hill
966-5884