Richard,

Thanks for the pointers.  You always know the answers to my questions, and
i appreciate you contributions to this group. I'm sure others do as well!

Ok, now i have my 3583 running, with new policy/management classes.  I
want to move data to it from the 3570, but only certain nodes.  The 3570
STGPOOL is NOT collocated (due to shortage of space/tapes) so a move by
volume would not work.

In other words, i need this command:  move data node='MYNODE' 3583STGP1

But alas it doesn't exist. :(  I searched the archives and see other
people have also had a use for this command, but did not find a solution.
Any ideas??  Thanks...

later!
Ray
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
Ray DeJean                                       http://www.r-a-y.org
Systems Administrator               Southeastern Louisiana University
IBM Certified Specialist              AIX Administration, AIX Support
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=


On Wed, 21 Feb 2001, Richard Sims wrote:

> >There is an extra slot at the top of each column of
> >18 tapes that seems to be the perfect spot for a cleaning tape.
>
> The 3583 Operator manual on page 6 defines that slot:
>
>     The nonaddressable slot located at the top of storage columns 2, 4, and 5
>     is reserved for future use. The bar code reader cannot read the label on
>     the cartridge if it is stored in the nonaddressable slot.
>
> Page 53 says:
>
>     The cleaning cartridge must be stored in one of the available storage
>     slots within the library.
>
> It identifies the cleaning cartridge by virtue of its "CLNI" volser prefix
> (page 114).
>
>  Richard Sims, BU
>