Re: Scratch Tape Problem
2001-02-21 16:02:55
Subject: |
Re: Scratch Tape Problem |
From: |
"Kelly J. Lipp" <lipp AT STORSOL DOT COM> |
Date: |
Wed, 21 Feb 2001 14:04:49 -0700 |
You might also be able to do this from the Web GUI. I remember a note from
last week where you could grab up a bunch of stuff and apply an action.
Are you sure your tapes were labeled in the first place, or are you certain
this is a drive problem? Both will cause this to happen.
I've found that by the time I figured out the select, dummied up a macro and
applied it, I could have issued update libvol commands and been done.
Granted I didn't learn anything except how bad I type, but I was done until
the next time.
Kelly J. Lipp
Storage Solutions Specialists, Inc.
PO Box 51313
Colorado Springs CO 80949-1313
(719) 531-5926
Fax: (240) 539-7175
Email: lipp AT storsol DOT com or lipp AT storserver DOT com
www.storsol.com
www.storserver.com
|
|
|