I checked and that file is
dated back from December of 99 and it is definitely from my last ADSM install. I
manually ran the dsmserv from a command prompt and it complained that the
database was from a downlevel version of the server and I needed to start it
with the UPGRADEDB parameter which I did. It hasn't finished yet so I don't know
if it is going to work but I thought that the upgrade was suppose to be
automatic...
Thanks for your
help,
Mark
Take a look in
the server folder for file initsrv3.log...it may have some indication of what
happened... maybe the upgradedb failed?
Hello
all, I just upgraded my ADSM 3.2.1.41 server to TSM 4.1.0.0. When I go into
the Server Utilities it says there is an error for Server1. When I try and
configure it in the Utilities wizard it doctor watsons out after I enter the
username and password. I am trying to manually start the service now but it
looks like I will have to go back to ADSM. It doesn't even log anything in
the Event viewer. Has anyone seen this behavior
before???
Thanks for any
help,
Mark Remeta Seligman Data
Corp. 100 Park Avenue New York, NY 10017
Confidentiality Note: The information transmitted is intended only for the
person or entity to whom or which it is addressed and may contain
confidential and/or privileged material. Any review, retransmission,
dissemination or other use of this information by persons or entities other
than the intended recipient is prohibited. If you receive this in error,
please delete this material immediately.
Confidentiality Note: The information transmitted is intended only for the person or entity to whom or which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of this information by persons or entities other than the intended recipient is prohibited. If you receive this in error, please delete this material immediately.
------_=_NextPart_001_01C023E7.D66C6450--
------_=_NextPart_000_01C023E7.D66C6450
|