Hello,

we don't have any problems letting compression ON for the clients and als=
o
doing hardware compression on the tape drives. I is true that this tape
compression has very few left to compress!

But it dosn't disturb nor influence the performance of migrations /
collocations

                Ren=E9 Lambelet
                Nestec S.A. / Informatique du Centre
                55, av. Nestl=E9  CH-1800 Vevey (Switzerland)
                *+41(021) 924 3543  7 +41 (021) 924 4589  * B 133
                mail to: rene.lambelet AT nestle DOT com

                This message is intended only for the use of the addresse=
e
        and may contain information that is privileged and confidential.


> -----Original Message-----
> From: Magura, Curtis [SMTP:curtis.magura AT LMCO DOT COM]
> Sent: Tuesday, February 01, 2000 12:18 PM
> To:   ADSM-L AT VM.MARIST DOT EDU
> Subject:      Compression - On / Off
>
> I have been following the compression thread the last day or so. My
> question
> is if you want / need to have compression at the client end what are yo=
u
> doing at the tape end?
>
> We are using compression at the tape drive (3494 - 4*3590-E). From what=
 I
> have read on the list and in the manuals you don't want software and
> hardware compression active at the same time.
>
> Are folks managing separate devclasses and pools with different
> compression
> settings and directing clients accordingly?
>
> Curt Magura
> Lockheed Martin EIS
> Gaithersburg, Md.
> 301-240-6305