> Apparently this command (show volumeusage <node>) only works
> for backup'ed data ...
>
> Any tips for archive ?
>
> Thanks.
>
>
> Frederic
> SP2 System Engineer Anderlecht
>
>
>
>
> -----Original Message-----
> From: Nathan King [mailto:nathan.king AT USAA DOT COM]
> Sent: Monday, December 20, 1999 10:46 PM
> To: ADSM-L AT VM.MARIST DOT EDU
> Subject: Re: SHOW VOLUME
>
>
> On the thread of SHOW. I found this lurking in my archives. It was posted
a
> while back, but here it is again.
>
>  <<debug.html>>
>
>         -----Original Message-----
>         From:   Remeta, Mark [SMTP:MRemeta AT SELIGMANDATA DOT COM]
>         Sent:   Monday, December 20, 1999 3:34 PM
>         To:     ADSM-L AT VM.MARIST DOT EDU
>         Subject:        Re: SHOW VOLUME
>
>         Hey! Thanks Richard. SHOW VOLUMEUSAGE works!
>         I never knew what the full command name was and just used SHOW
> VOLUME and it
>         use to work. I guess now you have to type the entire command out
and
> not
>         just VOLUME.
>
>         Mark
>
>
>         -----Original Message-----
>         From: rbs AT bu DOT edu [mailto:rbs AT bu DOT edu]
>         Sent: Monday, December 20, 1999 4:30 PM
>         To: MRemeta AT SELIGMANDATA DOT COM
>         Subject: SHOW VOLUME
>
>
>         Mark - Do you mean the 'SHOW' command itself is no longer
> recognized?
>                Or the subcommand?  Even if you fully spell it out as
>         'SHow VOLUMEUSAGE NodeName'?
>             If so, we'll have to do SQL Selects from now on.
Richard