I'm starting to setup ADSM 3.1.2.30 on a Solaris 2.6 host attached to a
Qualstar TLS412360 auto tape library. I'm also a bit new to unix so am not
sure about how tape device files are created for ADSM. Hopefully
someone can please advice...

The ADSM Administrator's Guide (Chapter 4) say to issue

    /usr/sbin/add_drv -m '* 0666 bin bin' /usr/kernel/drv/mt

but mentions nothing about issuing 'drvconfig' and 'tapes'. I'm assuming
these two commands are needed and are to be executed after the 'add_drv'
commandline above. Also, is a reboot needed at any point here?

Thanks in advance,

-Erin Peszko
=========================================================================