Re: Novell Client backup Error
1999-05-21 11:25:47
Here is what I would do.
1) free up one of the tapes that is only 1% used by doing a move data
to your disk storage pool.
2) Lower the reclamation percent to start reclamation.
Jim Sporer
______________________________ Reply Separator _________________________________
Subject: Re: Novell Client backup Error
Author: "ADSM: Dist Stor Manager" <ADSM-L AT VM.MARIST DOT EDU> at IPNET
Date: 5/21/99 9:14 AM
"Remeta, Mark" wrote:
>
> If reclamation is set to 100% reclamation will never occur.
> You need to lower the reclamation value to make it start. It should be lower
> than what the tape says is reclaimable.
> If you have the storage pool set for 10 scratch tapes (ie:maxscratch=10) and
> all 10 tapes are full you will not be able to perform the reclaim.
> Reclaiming takes data from multiple tapes which are full and writes this
> data to a new blank tape. After the reclaim operation is complete the old
> tapes that had the data on them are deleted from the volume history and
> returned to the scratch pool.
>
ok .... but with a reclamation set to 10 and a filling tape .... the
reclamation not occur. How can i force it ? when did the server normaly
start reclamation ?
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Re: Novell Client backup Error, (continued)
- Re: Novell Client backup Error, Andreas Buser
- Re: Novell Client backup Error, Remeta, Mark
- Re: Novell Client backup Error, Sebastien Chaumontet
- Re: Novell Client backup Error, Andreas Buser
- Re: Novell Client backup Error, Sebastien Chaumontet
- Re: Novell Client backup Error, Sebastien Chaumontet
- Re: Novell Client backup Error, Dwight Cook
- Re: Novell Client backup Error, Remeta, Mark
- Re: Novell Client backup Error, Sebastien Chaumontet
- Re: Novell Client backup Error, Lambelet,Rene,VEVEY,FC-SIL/INF.
- Re: Novell Client backup Error,
James SPORER <=
- Re: Novell Client backup Error, Sebastien Chaumontet
|
|
|