We have ours set up to fail over.  Basically, our tape drives & disk are
connected to both RS6000s but are only online to one.  If the RS6000
with ADSM fails, the volume groups get varied on the other system.  I
think we have to manually switch the tape drives (it's been a while
since we tested it).  The HA scripts then start the server.  All clients
point to the IP address that also fails over to the other RS6000, so
they don't see a difference.

I didn't do the HA work, but it seemed pretty simple and didn't need
anything special.

Tina Hilton

> -----Original Message-----
> From: Craig Corder [SMTP:ccorder AT SWBELL DOT NET]
> Sent: Monday, June 01, 1998 4:34 PM
> To:   ADSM-L AT VM.MARIST DOT EDU
> Subject:      ADSM and HACMP
>
> Dear All,
>     I am setting up a three node HACMP cluster.  Nodes A or B will
> failover there applications and disk drives to node C.
> Node A has ADSM Server software running on it and will failover to
> node
> C.
> Does anyone have any information on setting up ADSM Server to failover
> in a HACMP cluster?
> If so what steps did you go through in setup?
>
> Thanks in advance
> Craig Corder