Tape with write error going Read/Only
1998-04-08 08:55:13
I just started with ADSM v3.1 on AIX and have run into a problem. I have
one tape in a tape pool that went into "error state" and "read-only". It
shows that there is 1 write error. What is the recovery procedure for this
tape?
Thanks,
Frank M. Ramaekers Jr. Austin Community College Voice: (512)223-7619
Systems Programmer 5930 Middle Fiskville Rd. Fax: (512)483-7664
Information Services Austin, Texas 78752-4390
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Tape with write error going Read/Only,
Frank M. Ramaekers Jr. <=
- Re: Tape with write error going Read/Only, Sam Mauro
- Re: Tape with write error going Read/Only, Lindsay Morris
- Re: Tape with write error going Read/Only, Frank M. Ramaekers Jr.
- Re: Tape with write error going Read/Only, Eric van Loon
- Re: Tape with write error going Read/Only, Doug Thorneycroft
- Re: Tape with write error going Read/Only, Nicholas Cassimatis
- Re: Tape with write error going Read/Only, Mark Linehan
- Re: Tape with write error going Read/Only, Bonetti, Dan J.
- Re: Tape with write error going Read/Only, Thomas A. La Porte
- Re: Tape with write error going Read/Only, Kelly J. Lipp
|
|
|