-----BEGIN PGP SIGNED MESSAGE-----
Hi,
Hi,
Try using the tee command instead.
From the command line it would look like the following:
dsmadmc -id=xxx -pa=xxx 'q status' | tee -a qlist
That's the best way to get any output from ADSM. It will look just like the
screen you see.
Hope this helps.
Sean
On Tue, 27 Jan 1998, John Schuch wrote:
> The following batch command sends q status output to a
> file named qlist. The output format makes it very
> difficult to read the file contents because it contains a
> line width of about 500 characters.
>
> dsmadmc -id=xxx -pa=xxx q status > qlist
>
> When I issue the command interactively, and the output
> comes back to my screen it looks fine.
>
> Does anyone know how to force the output of the batch
> command, which is sent to file qlist, so that it is in
> the same format that appears when I run the command
> interactively and the output is directed to my screen.
>
> AIX 4.2.1.0
> ADSM 3.1.0.1
>
0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o
o 0
0 Sean P. Garvey, President phone: (703) 527-6036 o
o Phaedo Consulting, Inc. beeper:(800) 381-9779 0
0 www.phaedo.com email: sgarvey AT phaedo DOT
com o
o 0
0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o0o
|